Primary Electrician Training Device Didactic Equipment Teaching Electrical Lab Equipment

AFE2011 Primary Electrician Training Device Didactic Equipment Teaching Electrical Lab Equipment
1 Product overview 
1.1 Profile
This training device includes a variety of types of basic electrical control device and measurement, through the relevant experiment, can be familiar with lighting circuit, motor control circuit, measuring circuit connection methods, such as to master its control principle and control mode, the corresponding knowledge and skills, suits, higher vocational colleges, secondary vocational schools and vocational school related professional teaching and skills training examination.

1.2 Feature
1. The electrical control line components are installed on the mounting board of the wall board, which is convenient to operate and easy to replace, so as to facilitate the expansion of functions or develop new training; The choice of operation content is typical, practical and scientific.
2. The operating table can be put into use only with the ac power supply of three-phase four-wire;
3. The skills training with the control circuit and the special design of small motor, can simulate the factory in all kinds of electric drive system, can meet the installation, debugging, maintenance electrician, failure analysis and troubleshooting skills training requirements;

2 Capacity parameters 
(1)  Input power: three phases, five wires 380V±10% 60Hz
(2)  Dimension: 1600mm×800mm×1500mm
(3)  Whole capacity: ＜1.5KVA
(4)  Weight: ＜150kg
(5)  Work condition: environment temperature  -10℃～+40℃  
relative humidity ＜85%(25℃)

3 Product consist of
3.1   Power control panel 
The control screen is an iron double-layer subsurface airtight spray structure, aluminum plastic plate. The main control panel is equipped with resources: 
1.Three phase four wires power input, go through electrical rotector, main switch, go through start button, stop button, control contact connet or disconnect, and set emergency stop button. 
2.There is a 450V point type AC voltage meter 1 piece on control panel, through band switch can observe three electrical power grid voltage.    

3.2 Training workbench
The actual training table is an iron double layer subglazed structure, the tabletop is fireproof, waterproof, wear-resistant high density plate, the structure is firm, the modelling is beautiful and generous. There are two drawers (with a lock) on the left and right sides of the table, with cabinets, which can be used to place the hanging pieces and the actual training items, and the structure is strong and beautiful.
3.3Training components hanging box configuration
(1)Breaker and contactor module
(2)mutual inductor module 
(3)Single phase watt hour meter module
(4)Three phases watt hour meter module